Yamaha DSP-A595a Owner's Manual page 9

Natural sound av amplifier
Hide thumbs Also See for DSP-A595a:
Table of Contents

Advertisement

8
SPEAKERS
Set A or B (or both A and B) to the ON position for the main
speaker system (connected to this unit) that you want to use.
Set the button(s) for the main speaker system you don't want to
use to the OFF position.
9
EFFECT
Press this button once to switch the effect speakers (center and
rear) on or off. If you turn off the effect by using EFFECT, all
Dolby Digital and DTS audio signals are directed to the main
left and right channels. In that case, the left and right channel
signal levels may not match.
0
PROGRAM selector
Press one of these buttons to select a DSP program.
The name of the selected program appears on the display.
q
Tone controls
These controls are only effective for the sound from the main
speakers.
BASS
Use this control to increase or decrease the low-frequency
response. The "0" position produces a flat response.
TREBLE
Use this control to increase or decrease the high-frequency
response. The "0" position produces a flat response.
w
BALANCE
This control is only effective for the sound from the main
speakers.
Turn the control to adjust the balance of the output volume to
the left and right speakers to compensate for sound imbalance
caused by the speaker location or listening room conditions.
e
SET MENU
Press this button to select functions in the SET MENU mode.
r
TIME/LEVEL
Press this button to select the item in the TIME/LEVEL mode.
t
+/–
These buttons are used to adjust the settings of the SET MENU
mode and the TIME/LEVEL mode. In the TIME/LEVEL mode,
press + to increase the delay time or speaker output level.
Press – to decrease the delay time or speaker output level.
y
INPUT MODE
This button switches between the DVD/LD and TV/DBS input
signal modes.
u
VIDEO AUX terminals
Connect an auxiliary video or audio input source such as a
camcorder to these terminals. If the connected video unit has
an S video output terminal, connect it to the S VIDEO terminal
to obtain a high-resolution picture. The source connected to
these terminals can be selected by INPUT.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents