Controls And Their Functions - Yamaha DSP-A595a Owner's Manual

CONTROLS AND THEIR FUNCTIONS

FRONT PANEL
Refer to pages 35 to 40 for the remote control.
1
STANDBY/ON
Press this switch to turn on the power of this unit. Press it
again to set this unit in the standby mode.
Standby mode
In this state, this unit consumes a very small quantity of
power to receive infrared-signals from the remote control.
2
Remote control sensor
This receives signals from the remote control.
3
Display
This shows various information. (Refer to page 10 for details.)
4
TAPE/MD MON / EXT. DECODER
Press this button to play a tape or an MD. The "TAPE/MD
MON" indicator lights up on the display.
When you press the button next, the "TAPE/MD MON" indicator
goes off, "EXT. DECDR" appears on the display and you can
play the signal connected to the EXTERNAL DECODER
INPUT terminals.
8
5
INPUT
Turn this selector to select the input source (VCR, VIDEO AUX,
TV/DBS, DVD/LD, CD, TUNER, PHONO) that you want to
listen to or watch.
The name of the selected input source appears on the display.
6
VOLUME
This control is used to raise or lower the volume level.
7
PHONES jack
When you use headphones, connect the headphones to the
PHONES jack. You can listen to the sound to be output from
the main speakers through the headphones.
When using headphones only, set both SPEAKERS A and B to
the OFF position and switch off the digital sound field processor
(so that no DSP program name appears on the display) by
pressing EFFECT.