Setting The Clock; Adjusting Brightness Of The Display - Yamaha GX-500VCD Owner's Manual

Setting the clock

3–DISC VCD CHANGER
STANDBY TIMER
BASS
PHONES 1 MIC 2 TREBLE MIC MIXING
MIN MAX
AUTO REVERSE CASSETTE DECK DOLBY B NR
1
DISPLAY
2
RANDOM REPEAT MEMORY
HOUR MIN TIME ADJ
3
RANDOM REPEAT MEMORY
HOUR MIN TIME ADJ

Adjusting brightness of the display

1 2
DISC DISC DISC
YMERSION B.BOOST MUSIC
KARAOKE
MODE DOLBY NR REC/PAUSE
DISC 1 DISC 2 DISC 3 DISC CHANGE OPEN / CLOSE
PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
YMERSION B.BOOST MUSIC INPUT INPUT
KARAOKE RANDOM REPEAT TIME
HOUR MIN
MODE DOLBY NR REC/PAUSE AUTO/MANUAL MEMORY DISPLAY
TIMER TIME ADJ
STANDBY/ON
DIRECTION
Changes.
Changes.
3
DISC CHANGE OPEN / CLOSE
PRESET/ TUNING/ BAND A/B/C/D/E
VOLUME
DOWN UP
VOLUME
INPUT INPUT
RANDOM REPEAT TIME
HOUR MIN
AUTO/MANUAL MEMORY DISPLAY
DISPLAY
TIMER TIME ADJ
STANDBY/ON
Preparations and connections
1
While the power is on, press DISPLAY to display the time.
2
While holding TIME ADJ pressed, press HOUR and set the
hour.
* Press HOUR once to advance the time by 1 hour. Press
and hold to advance continuously.
3
While holding TIME ADJ pressed, press MIN and set the
minute.
* Press MIN once to advance the time by 1
minute. Press and hold to advance continuously.
* The hour setting will not advance even if minute is
advanced from "59" to "00".
Singapore model uses a 24-hour display. For China and
General models, either the 24-hour display or the 12-hour
display [shown by "AM (PM) 12:00"] is selected depending
on the setting of the FREQUENCY STEP switch on the
rear panel, so you cannot select the desired type freely.
Note
In the event of a power failure or when the AC supply lead is
disconnected, the time display will go out, however, the clock
will function for about 5 minutes without any power supply.
Otherwise, the time display will flash on and off to indicate that
the time must be reset.
If desired, you can adjust the brightness of the display.
Press and hold DISPLAY for more than 2 seconds so that
"DIMMER 0" appears on the display.
While holding DISPLAY pressed, turn VOLUME clockwise to
increase or counterclockwise to decrease brightness.
Control range: 0 to –6 (Preset value: 0)
E-7