5 ] Removing The Blind Cover, Power Supply Pcb, And Terminal Plates - Brother PT-530 Service Manual

[ 5 ] Removing the Blind Cover, Power Supply PCB, and Terminal Plates

(1) Remove the blind cover from the bottom cover by pulling the three pawls outwards with a
pointed tool.
(2) Pull out the positive (+) and negative (−) terminals of the battery power cords.
• Use a pointed tool to release locking pawls "p" of the terminals from the bottom cover.
• When handling those terminals, do not grip the cords but the terminal plates.
(3) Remove two screws from the power supply PCB, and then take it out together with the
grounding plate.
(4) Pull out terminal plate "a."
(5) Turn the bottom cover upside down and then remove terminal plates "b" with a pointed tool.
Figure 2.2-7 Removing the Blind Cover, Power Supply PCB, and Terminal Plates
II - 16