Steps
1. Place the display assembly on a clean and flat surface.
2. Align and place the palm-rest and keyboard assembly on the display assembly.
3. Using the alignment posts, close the display hinges.
4. Replace the two screws (M2.5x4) and (M2x3) that secure the left-display hinge to the system board.
5. Replace the two screws (M2.5x4) that secure the right-display hinge to the system board.
6. Connect the display cable on to the connector on the system board and adhere the tape to the system board.
Next steps
1. Install the
WLAN
card.
2. Install the battery.
3. Install the
base
cover.
4. Follow the procedure in
System board
Removing the system board - UMA
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
coin-cell
80
Disassembly and reassembly
after working inside your
before working inside your
battery.
computer.
computer.