Microphone Re-Assembly (Assemble Only After The Display/Keyboard Module Is Assembled)6-11; Figure 6-14. Display/Keypad Module Re-Assembly (2) - Motorola Commercial Series Basic Service Manual

Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
6.4.2.4 Microphone Re-assembly (assemble only after the Display/Keyboard Module is
assembled)
1. Check that the microphone felt is in position and not damaged. If damaged, replace felt.
2. Insert the microphone sub-assembly into the microphone boot.
3. Orientate the boot and microphone sub-assembly into the microphone recess in the housing, so
that the wires point at approximately 5 o'clock direction
in Figure 6-15.
4. Secure with Kapton tape in location shown in
68009328001-A

Figure 6-14. Display/Keypad Module Re-assembly (2)

Figure 6-15. Microphone Re-assembly
(Figure 6-15), then route wires as shown
Figure 6-15.
6-11
Wires orientated at
5 o'clock direction
Kapton tape
December, 2009