Figure 6-17. Microphone And Speaker Re-Assembly; Figure 6-18. Keyboard Flex Cable Connection - Motorola Commercial Series Basic Service Manual

Full Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
Note: Ensure that the plug orientation is correct with the exposed pins in the wire casing facing
upward and fully plugged in.
a. Connect the speaker wire assembly into the 2-pin connector on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
b. Connect the microphone wire assembly into the two hole socket on the main board and
bend the wires at the board connector so the wires are positioned toward the top of the
radio
c. Slide the audio jack shroud onto accessory connector
2. Position the radio
connector located on the bottom of the main board, pushing up the 2 end tabs.
3. Slide the volume potentiometer and frequency switch shafts into their respective holes in the front
cover. Look through the accessory connector opening to make certain that the wires are not
pinched, between shroud and housing.
4. Push the topside of the board chassis upward until it touches the housing end. Before snapping
68009328001-A
(Figure 6-17).
(Figure 6-17).
Microphone
Connector

Figure 6-17. Microphone and Speaker Re-assembly

(Figure 6-18), and reconnect the flex connector from the keyboard into the

Figure 6-18. Keyboard Flex Cable Connection

(Figure 6-16).
Speaker Connector
Radio Chassis
End Tabs
December, 2009
6-13