Table of Contents
Advertisement
The Silent Bass uses a battery as its power source.
Before installing or removing the battery, remove the cable from the output
jack.
1
On the backside of the instrument, push down on the battery case's latch below the "OPEN" arrow
to remove the battery case.
• Be careful when removing the battery case. Depending upon the angle of the instrument, the
case can suddenly jump out.
2
Insert the supplied battery (6F22(S-006P)9V battery) into the case. Referring to the illustration
below, make sure that the battery is placed in the case with its poles (+/-) properly aligned.
3
Push the case into the slot until you hear the latch "click".
Latch
* For customers in the Netherlands
Bij dit produkt zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.
When the battery is low, the lamp will dim and the sound may become distorted or noisy.
When these symptoms occur, please take note of the following precautions and replace the battery.
• Always follow the +/– signs when inserting the battery. Improper insertion may result in fire.
• To prevent possible damage to the unit due to battery leakage and unnecessary power drain, remove
the battery from the unit when it is not going to be used for an extended period of time.
14
Power Supply
6F22 (S-006P)
9V battery
battery
compartment
Caution! When Inserting the Battery
In some cases, batteries other than the
supplied battery may be slightly short in
length resulting in poor conductivity (loss
of power). In this case, refer to the illus-
tration on the left and use a spacer, such
as some thick paper or a piece of card-
board, between the end of the battery and
the battery case to hold the battery in
place.
Advertisement
Table of Contents
