Selecting & Playing A Song; The Song Mode Chord Display - Yamaha QR10 Owner's Manual

6: Playing the Preset Songs
Selecting & Playing a Song
Select the Song Mode
1
If is showing in the upper left corner
PATTERN
of the display, press the [PATTERN/SONG] key to
switch to the mode.
SONG
Select a Song Number
2
Use the [–1] and [+1] keys or the numeric keys
to select the number of the song you want to play.
The preset songs are numbered from "00" to "49".
If you select a song number
DETAIL
between 50 and 99, and the song has
not yet been recorded, a series of
dashes will appear on the display.
Start Playback
3
Press the [START/STOP] key to begin playback of the selected song. Make sure that the VOLUME control is set to an
appropriate level. As the pattern plays a triangular beat indicator will flash in time with the music.

The SONG Mode Chord Display

During song playback the current chord is
displayed immediately under "CHORD" on
the display, and the next chord (i.e. the chord
that will begin playing at the top of the next
measure) is shown below the triangular beat
indicator.
If you press a section key during song playback, the selected section — INTRO, NORMAL, VARIA-
DETAIL
TION, or ENDING — will begin playing from the top of the next measure (FILL 1 and FILL 2 begin as
soon as the key is pressed), but only until the next programmed section change.
Pattern Number
or
Chord
Type
Song
Number
23