Registering The Panel Settings - Yamaha PSR-9000 Owner's Manual

Registering the Panel Settings

You can also create your own Registration Memory setups.
1
Set up the panel controls as required.
2
Select a Registration Bank (04 through 64).
Avoid selecting one of the Registration Banks 01 through 03 (even though they
can be selected), since you may inadvertently delete some important data.
(See the "NOTE" note below.)
3
Press the [MEMORY] button.
The LCD display will prompt you to select the desired Registration number.
Press the [MEMORY] button again to exit from this display.
4
Press one of the REGISTRATION MEMORY buttons: [1]
through [8].
REGISTRATION MEMORY
FREEZE
1
1
In this example, the panel settings are memorized to button number 3.
Since all Registration Memory data is stored to Flash ROM, any data in the Registration Memory location you selected
in step #2 above will be erased and replaced by your new settings. This includes the factory programmed preset Reg-
istration Memory settings (banks 01 - 03). If you've deleted the factory-set data, you can use the Restore function
(page 130) to load a copy of it from the included disks (page 6).
BANK 01
1 2 3 4
For details about Flash ROM, refer to "Memory Structure" on page 50.
REGISTRATION MEMORY
FREEZE REGISTBANK 1~64
BAN
1 2 3
1 2 3
MEMORY
REGISTRATION
ONE TOUCH SETTING
REGISTBANK 1~64
BANK VIEW
2 3 4 5 6
2 3 4 5 6
5 6 7 8
7 8
7 8
Registration Memory banks
64 banks in Flash ROM
All banks can be edited.
04~64
These banks do not
contain preset setups.
01~03
These banks contain preset
setups (factory settings).
Registration Memory
29
Quick Guide