Panel Control; Octave; Note; Type Select & Sub - Yamaha PortaTone PSR-7000 Owner's Manual

NOTE

This switch turns reception of the note data on or off. When off, no notes will be produced by the
PSR-7000 even when note data is received on the selected channel.
CNTCNG Turns reception of control change data on or off. Control change data includes modulation wheel, foot
controller, and any other controller data (except the pitch bend wheel, which has its own switch, be-
low).
PRGCNG Turns reception of program change data on or off. Program change data corresponds to voice or
"patch" numbers, and will select the corresponding voices on the PSR-7000 when the PRGCNG pa-
rameter is on.
PITCHBND Turns reception of pitch bend wheel data on or off.
AFTERTCH Turns reception of keyboard aftertouch data on or off.
The parameters in this display page assign specific PSR-7000 panel controls to notes. The assigned notes
then control the corresponding panel control operations when received via a MIDI channel which is set to the
receive mode in the

OCTAVE

Use either the s and t LCD buttons to the left
of the display, or the
octave in which you want to assign a note. The
selected octave appears between the s and t LCD
buttons to the left of the display. The "C" note in
octave "3" corresponds to C3 (middle C) on the
keyboard.
NOTE
Use the LCD dial to select the note to
which you want to assign a panel control function.
TYPE SELECT & SUB
Use the
panel control function to the selected note. The
available panel control function types are listed
below along with the corresponding note-on (note
played) and note-off (note released) events for each
type. In some cases the
are also used for type selection, as listed below.

PANEL CONTROL

display, above.
LCD dial to select the
LCD dials to assign a
and LCD dials
F8: MIDI
129