Yamaha PortaTone PSR-7000 Owner's Manual page 117

When the ,
type is selected, use the
LCD dials to turn footswitch control for the corre-
sponding parts or
The type can be independently as-
signed to the ORGAN voice.
NOTES
• The sustain effect is applied to the specified orchestra
part(s) only when the panel [SUSTAIN] button is turned on
or when the sustain pedal is pressed.
• The panel [SUSTAIN] button will not function while a
footswitch to which the sustain effect is assigned is used.
SUSTAIN
SOSTENUTO
SOFT
TAP TEMPO
REGISTRATION +
REGISTRATION –
START/STOP
ROTARY SPEAKER
HARMONY
INTRO/FILL to A
INTRO/FILL to B
ENDING/rit.
FADE IN/OUT
F.CHORD 1/2
BASS HOLD
PERCUSSION
ACCOMP. BREAK
PUNCH IN/OUT
, or
, , , and
as required.
Standard sustain footswitch operation. When the footswitch is pressed notes played have a
long sustain. Releasing the footswitch immediately stops (damps) any sustained notes.
If you play a note or chord on the keyboard and press the footswitch while the note(s) are
held, those notes will be sustained as long as the footswitch is held (as if the damper pedal
had been pressed) but all subsequently played notes will not be sustained. This makes it
possible to sustain a chord, for example, while other notes are played "staccato."
Pressing the footswitch subtly reduces the volume and slightly changes the timbre of notes
played. The SOFT effect only applies to certain voices — PIANO, for example.
While the accompaniment is stopped, or during the SYNCHRO START mode before the
accompaniment is started, the footswitch can be used to set any desired tempo (within the
PSR-7000's 32 to 280 beats per minute range) by simply tapping on the switch at the re-
quired tempo.
Tap 4 times for an accompaniment with a 4/4 time signature, 3 times for 3/4, and 5 times for
5/4.
If the accompaniment is started before the required number of taps has been entered, the
Tap Start setting will be ignored. The Tap Start setting will also be ignored if several sec-
onds elapse before the required number of taps have been entered, if a different style is
selected, or if the accompaniment [START/STOP] button is pressed.
Recall next highest (increment) registration. "1-1" is selected after "16-8".
Recall next lowest (decrement) registration. "16-8" is selected after "1-1".
Same as panel [START/STOP] button.
Alternately selects the SLOW and FAST speeds of the rotary speaker when a DSP EFFECT
Rotary Speaker effect is selected (page 120).
Harmony occurs only while footswitch pressed.
Same as panel [INTRO/FILL to A] button.
Same as panel [INTRO/FILL to B] button.
Same as panel [ENDING/rit.] button.
Same as panel [FADE IN/OUT] button.
The footswitch alternately switches between the ABC FINGERED 1 and FINGERED 2
modes (page 24).
Holds the bass note so that "pedal bass" progressions can be produced using ABC.
Footswitch plays a percussion instrument selected by the ASSIGN LCD dials (the latter
appears when the PERCUSSION type is selected).
Pressing the footswitch produces a break in the accompaniment for as long as the pedal is
held. The accompaniment will start again from the top of the next odd-numbered measure
when the pedal is released.
Sets punch-in and punch-out points when song record mode is set to "Punch" (page 69).
F3: Controller
113