Table of Contents
Advertisement
Chapter 1: Maintaining and Upgrading the Hardware
Installing a hard disk drive
Warning: Do not swap hard disk drives from one Sun Cobalt
Control Station to another. Also, do not install a drive, that was
previously partitioned for RAID, in a Sun Cobalt Control Station as
an additional (non-RAIDed) drive.
Caution: Be careful not to damage components during the upgrade.
!
Caution: Wear an electrostatic discharge (ESD) grounding wrist
strap.
!
To install a hard disk drive:
1. Place the new hard disk drive in the bracket that you removed in the previous
procedure.
2.
On the underside, attach the hard disk drive to the bracket with the four
screws.
Caution: Be careful not to pinch the cables under the bracket when
you replace the bracket on the chassis.
!
3.
Set the bracket with the attached hard disk drive on the chassis and slide it
onto the metal tabs. The connectors on the hard disk drive must face in to the
center of the chassis, with the foam pad located next to the power supply.
4.
Re-attach the bracket to the chassis with the correct screw.
12
Upgrading the Hardware—Sun Cobalt Control Station
Advertisement
Table of Contents
