Ez Chord - Recording - Yamaha Portatone PSR-340 Owner's Manual

AUTO ACCOMPANIMENT — THE STYLE MODE
EZ Chord — Recording
1
Enable recording.
Press the RECORD button, repeatedly if necessary, until EZ Chord
recording is selected. ("EZ" appears in the display and the
"RECORD" indication flashes for a couple of seconds.)
2
Select the desired EZ Chord bank.
Use the numeric keypad. Buttons 1 - 8 select EZ Chord banks #1 -
#8, respectively.
3
Start recording.
When the "RECORD" indication stops flashing (and is lit continu-
ously), you can start recording. Recording chords in EZ Chord is
essentially a three-step operation:
1) Select the desired block with the +/- buttons.
2) At the selected block, record the desired chord.
You can do this in one of two ways:
• Play Multi Fingering chords in the auto accompaniment
section. (See page 56.)
• Enter the chord root and name manually from the
ROOT and CHORD TYPE section of the keyboard.
68
RECORD indication flashes
briefly.
EZ
3
STYLE
RECORD
ACMP ON
RECORD
ACMP ON
3 025 -
Indicates the
chord position.
RECORD
ACMP ON
3 025 -
Block number (128 are available in a bank)
Bank number
Currently selected
block flashes.
Indicates the
M
7 recorded chord.
— Clearing
the Bank
Before recording, you may
want to erase (clear) all
recorded chords for the
selected EZ Chord bank. For
instructions on doing this,
see "Clearing an EZ Chord
Bank" on page 71.
Even if you've recorded over
(erased) the factory set EZ
Chord banks, you can
restore the original banks.
(See page 111.)
1 — 16 Block
17 — 32 Block
33 — 48 Block
49 — 64 Block
65 — 80 Block
81 — 96 Block
97 — 112 Block
113 — 128 Block