Bass, Chord, Pad And Phrase Part Recording; Clear The Recorded Drum Voice - Yamaha PSR-S650 Reference Manual

3
Play the keyboard and record the drum Voices.
Since the entire Style plays repeatedly, you can record at any point you like.
4
Press the [START/STOP] button to stop recording.
 Clear the recorded drum Voices
To clear the recorded drum Voices, after starting recording (refer to step 2 of the
recording operation above), follow the instructions below.
1 Press and hold the [-] button and play the key or keys that correspond to the
cleared Voice.
2 Press the [START/STOP] button to exit from the clear operation.

Bass, Chord, Pad and Phrase Part recording

If you select Parts other than a rhythm Part for recording part on
instructions below.
1
Make sure that the desired Part (other than rhythm) is selected
for recording.
The button corresponding to the Part to be recorded lights in red.
In this condition, a REC mark also appears at the recorded Part on the display.
2
Press the [START/STOP] button to begin recording.
3
Play the keyboard and record your playing.
Rules for recording to non-rhythm Parts:
For information on recording to parts other than the rhythm parts (RHY1, 2),
refer to the section below, and perform using notes that match the chord CM7.
• Use only the CM7 scale tones when recording the Bass and Phrase Parts (i.e.,
C, D, E, G, A, and B).
• Use only the C chord tones when recording the Chord and Pad Parts (i.e., C,
E, G, and B).
Using the data recorded here, the auto accompaniment (Style playback) is
appropriately converted depending on the chord changes you make during your
performance. The chord which forms the basis for this note conversion is called
the Source Chord, and is set by default to CM7 (as in the example illustration
above)
4
Press the [START/STOP] button to stop recording.
Record to other Parts in other sections.
5
Save the Style data
C = Chord note
C, R = Recommended note
C R C C R C
(page 42).
Creating Original Styles (Style Creator)
NOTE
• Only the rhythm Part can be
page 38, follow the
NOTE
• The Part you have selected
NOTE
• Any desired chord or chord
cleared in this operation;
other Parts (e.g., bass or
chord) cannot be cleared.
may be changed if you
select the section again.
progression can be used for
the INTRO and ENDING
sections. If you record each
sections keeping in mind the
section shifts (Intro  Main
 Fill in  Main  Ending),
you can achieve better
results.
39
Reference Manual