Data Backup & Initialization - Yamaha Portatone PSR-340 Owner's Manual

Problem
A strange "flanging" or "doubling" sound
occurs when using the PortaTone with a
sequencer. (This may also sound like a "dual"
layered sound of two voices, even when Dual
is turned off.)
The footswitch seems to produce the opposite
effect. For example, when using the footswitch
for sustain, pressing the footswitch cuts off the
sound and releasing it sustains the sounds.
The sound of the voice changes from note to
note.
Nothing happens or nothing seems to
function, even when pressing a panel button.
For example, pressing the DEMO button does
not start the Demo song, or playing the
keyboard does not produce any sound.
DATA BACKUP & INITIALIZATION
Except for the data listed below, all PSR-340 panel settings are reset to their initial settings
whenever the power is turned on. The data listed below are backed up — i.e. retained in
memory — as long as an AC adaptor is connected or a set of batteries is installed.
• User Song Data
• User One Touch Setting Data
• One Touch Setting Bank Number
• EZ Chord Data
• EZ Chord Bank Number Data
• Smart Chord Number
• Style 101 Data
Data Initialization
All data can be initialized and restored to the factory preset condition by turning on the
power while holding the highest (rightmost) white key on the keyboard. "CLr Backup" will
appear briefly on the display.
• If you are routing the MIDI OUT on the PortaTone to a
sequencer and back to the MIDI IN, you may want to set Local
Control (page 107) to "off" to avoid MIDI "feedback."
• When using the accompaniment with a sequencer, set MIDI
Echo (or the relevant control) to "off." (Refer to the owner's
manual of your particular device and/or software for details.)
The polarity of the footswitch is reversed. Make sure that the
footswitch plug is properly connected to the FOOT SWITCH jack
before turning on the power.
The AWM tone generation method uses multiple recordings
(samples) of an instrument across the range of the keyboard;
thus, the actual sound of the voice may be slightly different from
note to note.
One of the the disk-related displays (SAVE, LOAD, DELETE, or
FORMAT) is shown. Exit from the display by pressing the SAVE
button (from the SAVE display), the LOAD button (from the
LOAD display), or the UTILITY button (from the DELETE or
FORMAT displays).
• Metronome Volume
• Touch On/Off
• Touch Sensitivity
• Split Point
• Accompaniment Split Point
• Footswitch Assign Function
Backup
CLr
VOICE
STYLE
TROUBLESHOOTING
Possible Cause and Solution
CAUTION
• All one touch setting
(user) and song memory
data, plus the other settings
listed above, will be erased
and/or changed when the
data initialization proce-
dure is carried out.
• Carrying out the data
initialization procedure will
usually restore normal
operation if the PSR-340
freezes or begins to act
erratically for any reason.
111