Mono Input Cue/Solo Switch: Pre-Fader Or Follow Mt Pre Switch - Yamaha PM4000 Operating Manual

6.4 Mono Input Cue/Solo Switch: Pre-
Fader or Follow MT PRE Switch
As shipped from the factory, the mono input channel
CUE/SOLO switch applies signal to the left and right
cue busses from a point which is derived just ahead of
the channel fader (actually, just ahead of the fader-
controlled VCA). However, an internal jumper in each
mono input module enables this function to be altered
Figure 6-4. Internal Switch Positions For Cue/Solo being Pre-Fader
or tracking the METER PRE Switch on Monaural Input Module,
and Corresponding Block Diagram Location.
Page 6-5
so that the take-off point for the cue/solo signal tracks
the signal feed to the channel's LED level meter. In
this way, the cue/solo feed will be post-fader (or post-
VCA to be more exact) until the METER PRE switch is
set to Pre mode; then it will be pre-fader. The channel's
CUE output has left and right components, but both
are derived from the same monaural signalThe switch
positions are illustrated below in Figure 6-4.