Stereo Input Channel Feed To Monitor; Module St In 3 Or St In - Yamaha PM4000 Operating Manual

6.11 Stereo Input Channel Feed to
Monitor Module ST IN 3 or ST IN 4
The Monitor module has provisions for selection and
monitoring of signals assigned from the "Stereo In 3"
and "Stereo In 4" modules. However, the stereo module
numbers are arbitrarily designated; stereo modules can
be located in just about any mainframe input module
location, and more than one can contribute to the ST
IN3 or ST IN4 monitor mix.
Figure 6-11. Internal Switch Position For Stereo Input Module Signal Assigned to
ST IN3, ST IN4 or neither Monitor Selection, and Block Diagram Location.
Determination of which stereo modules actually
contribute to the monitors when the monitor module's
ST IN3 or ST IN4 switch is engaged is dependent on the
position of a slide switch in each stereo input module.
Locate the switch (Fig. 6-11) and set it as shown so
that a given module either does not contribute anything
to these monitor busses, or so it contributes to ST IN3
or ST IN4 bus.
Page 6-12