Table of Contents
Advertisement
Message List
Message
No response
from USB device
Please wait
Protected device
Read-only file
Remaining space
on drive is low
Same file name exists
Song error
Song too large
System limit
This data format is not
supported
Unformatted device
Unsupported device
USB device
overcurrent error
USB hub
hierarchical error
USB power consumption
exceeded
Wrong device
Wrong name
112
CLP-785, CLP-775, CLP-745, CLP-735, CLP-795GP, CLP-765GP Owner's Manual
The instrument cannot communicate with the connected USB device. Redo the connection (page 74). If
you still see this message, the USB device may be damaged.
The instrument is processing the data. Wait until the message disappears, then go on to the next step.
This message appears when you attempt a file operation (page 65), record your performance or save the
data on a read-only USB flash drive. Cancel the read-only setting, if possible, and try again. If you still see
this message, the USB flash drive is internally protected (such as commercially available music data). You
cannot make the file operation or record your performance to such a device.
You attempted a file operation to a read-only file. Read-only files have handling limitations (page 65), and
cannot be used for editing (page 61). Use a read-only file after overriding the read-only setting.
Since the remaining space on the "User"/USB flash drive is low, delete any unnecessary files (page 67)
before recording.
This message appears to prompt you to confirm if overwriting or not when executing a Copy/Move/
MIDI to Audio operation.
This message appears, if a problem is found with the Song data when you select a Song or while the Song
is playing. In this case, reselect the Song, and try again to play back. If the message still appears, the Song
data may have been damaged.
The size of Song data (MIDI/Audio) exceeds the limitation. The following causes can be considered.
• The Song size you attempt to play back exceeds the limitation. The limitation for playback is approx.
500KB (MIDI), 80 minutes (Audio).
• The Song size exceeds the limitation during recording. The limitation for recording is approx. 500KB
(MIDI), 80 minutes (Audio). The recording will end automatically and the recorded data before the end is
saved.
• The Song size exceeds the limitation during converting a MIDI Song to an Audio Song. The limitation is 80
minutes (Audio).
This message appears when the number of files exceeds the system limit. The maximum number of files
and folders which can be saved in a folder is 250. Try again after deleting/moving the unnecessary file(s).
This message appears when you attempted to load a Song of unsupported format to this instrument. Refer
to the page 43 about supported Song formats.
This message appears when you attempt to use an unformatted USB flash drive. Format it (page 100), and
try again.
This message appears when an unsupported USB flash drive is connected. Use a device whose
compatibility has been confirmed by Yamaha (page 74).
Communication with the USB device has been cut off because of an abnormal power surge to the device.
Disconnect the USB device from the USB [TO DEVICE] terminal and turn the [P] (Standby/On) switch of
the instrument standby and on again.
The USB hub is connected in two layers. USB hub use is limited to one layer.
A bus-powered USB hub is usually recommended. When this message appears, however, use a self-powered
USB hub (with its own power source) and turn the power to on, or use a device whose compatibility has been
confirmed by Yamaha (page 74).
The file operation cannot be made to the connected USB flash drive. The following causes can be
considered.
• The USB flash drive in not formatted. Format it (page 100), and try again.
• The number of files exceeds the system limit. The maximum number of files and folders which can be
saved in a folder is 250. Try again after deleting/moving the unnecessary file(s).
The Song name is not appropriate. This message appears during the "Renaming files" (page 70) operation
because of the following causes. Rename the Song correctly.
• No character has been input.
• You used a period or space at the beginning/ending of a Song name.
Meaning
Advertisement
Table of Contents
