Turning the Power On
and Off
Connect the power cord
1
Insert the plugs at the ends of the cord, one into the
AC INLET on the Clavinova, and the other into a
standard AC outlet.
In some areas, a plug adapter may be provided to
match the pin configuration of the AC wall outlets in
your area.
(The shape of plug differs depending on locale.)
2
Press the [POWER] switch.
→
The main display appears in the LCD display. The
drive lamp below the lower right end of the
keyboard also lights.
POWER
ON
OFF
A
B
C
D
E
BALANCE
CHANNEL
ON OFF
PART
When you're ready to turn off the power, press the
[POWER] switch again.
→
Both the display and the drive lamp below the
right end of the keyboard will turn off.
The drive lamp lights.
BACK
Setting the volume
Use the [MASTER VOLUME] dial to adjust the volume to
an appropriate level.
MASTER VOLUME
MIN
CAUTION
Do not use the Clavinova at a high volume level for a long period of
time, or your hearing may be damaged.
Using headphones
Connect a pair of headphones to one of the [PHONES]
jacks.
Two [PHONES] jacks are provided.
Two sets of standard stereo headphones can be plugged
in. (If you are using only one pair of headphones, you
can plug them into either of these jacks.)
INPUT
MIC.
MIC. LINE
PHONES
VOLUME
LINE IN
MIN
MAX
Using the Headphone Hanger
A headphone hanger is included in the CVP-210/208
package so that you can hang the headphones on the
Clavinova. Install the headphone hanger using included
two screws (4
10 mm) as shown in the figure.
CAUTION
Do not hang anything other than the headphones on the hanger.
Otherwise, the Clavinova or the hanger may be damaged.
FADE IN / OUT
MAX
CVP-210/208
17