Voltage Selector - Yamaha Clavinova CLP-230 Owner's Manual

4.
Attach A.
4-1
Secure A using 6 x 16 mm short screws from the
front.
4-2
Firmly tighten the screws you temporarily
secured in steps 2-2 and 2-3 above (assembly B).
Tighten these in order starting with the top side
first, then the bottom. Make sure as you do this
that the spaces on the left and right sides
(indicated by 1 and 2 below) are even.
1
4-2
5.
Connect the pedal cord.
5-1
Insert the pedal cord plug to the pedal connector
from the front.
5-2
Attach the cord holders to B, then clip the cord
into the holders.
5-3
Use a twist tie to bundle the pedal cord.
CLP-240
5-3
5-2
2
6.
4 -1
5-1
CLP-240/230: Keyboard Stand Assembly
CLP-230
5-3
5-2
Connect the power cord.
127
240
Insert the AC power cord plug into the AC
INLET.
For models that feature a voltage selector:
Set the voltage selector to an appropriate voltage.

Voltage Selector

Before connecting the AC power cord, check the set-
ting of the voltage selector which is provided in some
areas. To set the selector for 110V, 127V, 220V or 240V
main voltages, use a "minus" screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially
shipped. After the proper voltage has been selected,
connect the AC power cord to the AC INLET and an
AC wall outlet. A plug adaptor may be also provided
in some areas to match the pin configuration of the
AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious
damage to the Clavinova or result in improper
operation.
5-1
CLP-240/230 Owner's Manual
67