Initial Setup Send - Yamaha Clavinova CLP-230 Owner's Manual

Detailed Settings – [FUNCTION]
/ F7.6:
F8.6:
(CLP-240)
Panel/Status Transmit
This function causes all the current CLP-240/230 panel
settings (selected voice, etc.) to be transmitted via the
MIDI OUT terminal.
Setup Data:
Data that contains a set of panel settings for the Clavinova.
Procedure
1. Set up the panel controls as desired.
2. Connect the Clavinova to a sequencer via MIDI, and
set up the sequencer so it can receive the setup data.
3. Engage the Function mode and select
240)/ (CLP-230).
4. Press the
[+/YES]
data.
will appear on the LED display when the data has
been successfully transmitted.
See page 81 for a list of the "Panel Data Contents" transmitted
by this function.
Receiving the transmitted data:
1. Connect the Clavinova via MIDI to the device to which the
setup data was transmitted previously.
2. Start sending the setup data from the device.
The Clavinova automatically receives the setup data, which will
be reflected in the panel settings.
(For the data to be accepted, the Clavinova that receives the
setup data should be the same model as the one that transmit-
ted the setup data to the sequencer.)
For more information on transmitting and receiving setup data
via MIDI, refer to the owner's manual for the connected MIDI
device.
54
CLP-240/230 Owner's Manual
(CLP-230)
TERMINOLOGY
(CLP-
button to transmit the panel/status
NOTE
NOTE
NOTE
/ F7.7:
F8.7:
(CLP-240) (CLP-230)

Initial Setup Send

This function lets you send the data of the panel settings
to a computer. By transmitting the panel settings and
recording them on the MIDI sequence recorder prior to
the actual performance data, the instrument will be
automatically restored to the same settings when the per-
formance is played back. You can also use this function to
change the settings of a connected tone generator to the
same settings as the instrument.
Procedure
1. Set up the panel controls as desired.
2. Connect the Clavinova to a sequencer via MIDI, and
set up the sequencer so it can receive the setup data.
3. Engage the Function mode and select
240)/ (CLP-230).
4. Press the button to transmit the panel/status
[+/YES]
data.
will appear on the LED display when the data has
been successfully transmitted.
The following data can be sent.
• Voice selection
• [REVERB] type
• [REVERB] depth
• [EFFECT] type
• [EFFECT] depth
• Split point
• Tuning (F1)
• Dual detune (F3.2)
(CLP-