Yamaha Clavinova CLP-820 Owner's Manual page 63

2
D
D
5 x 40 mm long gold screws
If applicable, align the
cut corner of the
bracket with the corre-
sponding cutouts on
the feet.
1
X
Assemble the side panels (D) and feet (E).
Secure the feet (E) to the side panels (D) with the 5 x 40
millimeter long gold-colored screws 1 (3 each).
Depending on the unit type, the feet (E) may or may not have
cutouts. If the feet have cutouts, make sure that the cutouts on the
feet face the bracket side of the side panels.
Attach the side panels (D) to the pedal box
C
(C).
Before installing the pedal box, untie and straighten out the
bundled cord attached to the bottom of the pedal box. Don't dis-
card the vinyl tie, you'll need it later in step N.
Place the pedal box on top of the brackets attached to the side
panels (D), and attach using the four 6 x 20 millimeter round-
head screws 2 — two screws on each side. Make sure the pedals
extend in the same direction as the feet.
3
6 x 20 mm round-head screws
D
2
D
C
CLP-880/860/840/820/820S
63