Yamaha S70 XS Owner's Manual page 32

Bottom section
1
2
1 Controller Set status
This section indicates which controller of the S90 XS/S70 XS (either built-in or connected) is used as the
Control Source of the Controller Set edited in the RCV/Control Set window.
1 Part
Indicates the current Part. When [Voice]/[Multi] is set to "Voice" (Voice mode is enabled), in the Voice
mode, this indication is fixed to "1." When the [Voice]/[Multi] is set to "Multi" (Multi mode is enabled), in the
Multi mode, this indication is determined by selecting the Part in the Mixer section.
2 Control Source
Indicates the six controllers as source of the Controller Set. The abbreviations for the Controllers are as
follows:
Indication
PB
MW
AT
FC
FS
RB
3 On/Off status
When a lamp is turned on, a certain function (Destination) is assigned to the corresponding Source
(controller). When a lamp is turned off, no function (Destination) is assigned to the corresponding Source
(controller).
2 Quick Setup
From this section, you can instantly call up appropriate settings related to the MIDI parameters.
n
The settings of the S90 XS/S70 XS instrument made via the operation here cannot be saved as an Editor file.
You can select a template from 1 – 3. On the S90 XS/S70 XS instrument, this section is the same as the
Quick Setup parameter on the Utility Quick Set display.
n
The parameters set via the Quick Setup can be edited on the Hardware Utility window
S90 XS/S70 XS Editor Owner's Manual
3
6
1
Control Source
Pitch Bend Wheel
Modulation Wheel
After Touch (keyboard)
Foot Controller
Foot Switch
Ribbon Controller
S90 XS/S70 XS Editor Window: Bottom section
4
7
2
3
Indication Control Source
BC Breath Controller
AS1 ASSIGN 1 knob
AS2 ASSIGN 2 knob
FC2 Foot Controller 2
AF1 ASSIGNABLE FUNCTION 1 button
AF2 ASSIGNABLE FUNCTION 2 button
5
(page 43).
32