Synchronous Spindle; Signals To Axis/Spindle (Db31; Signals From Axis/Spindle (Db31 - Siemens SINUMERIK 840D sl Function Manual

NC/PLC interface signals (Z2)

19.14 Synchronous spindle

19.14 Synchronous spindle
19.14.1

Signals to axis/spindle (DB31, ...)

DB31, ...
DBX31.5
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Corresponding to ....
19.14.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX84.4
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Corresponding to ....
DB31, ...
DBX98.0
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
1068
Disable synchronization
Signal(s) updated: Cyclic
The synchronization motion for the following spindle is not disabled from the PLC.
The position offset is not suppressed and applied as in earlier versions.
The synchronization motion for the following spindle is disabled from the PLC.
A synchronization motion specified via offset programming is suppressed for the following
spindle. The following spindle does not execute any additional movement.
DB31, ... DBX98.1 (Synchronism coarse)
DB31, ... DBX98.0 (Synchronism fine)
Synchronous mode
Signal(s) updated: Cyclic
The spindle is operating in "Synchronous operation" mode. The following spindle thus follows
the movements of the leading spindle in accordance with the transmission ratio.
The monitoring functions for coarse and fine synchronism are implemented in synchronous
operation.
Note:
The signal is set only for the machine axis which is acting as following spindle
(IS "FS active" = 1)
The spindle is not operated as the following spindle in "synchronous mode".
When the coupling is deactivated (deselection of synchronous operation), the following
spindle is switched to "open-loop control mode".
DB31, ... DBX98.0 (Synchronism fine)
DB31, ... DBX98.1 (Synchronism coarse)
DB31, ... DBX99.1 (FS active)
Fine synchronism
Signal(s) updated: Cyclic
The positional deviation or velocity difference between the following spindle and its leading
spindle is within the "Fine synchronism" tolerance band.
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions