Siemens SINUMERIK 840D sl Function Manual page 1116

Index
I
I/O device interface, 598
I/O range, 54
Configuration, 55
Configured length, 54
Start address, 54
System variables, 57
Identification
Operator panels, 126
Identification of spindles, 490
INC, 930, 931
INCH or METRIC unit of measurement, 615
Inclined axis
TRAANG, 522
Inclined axis transformations, 564
Incremental travel, 284
Incremental travel (INC), 931
Continuous operation, 285
Jog mode, 285
Indexing axes
Coded position, 936
FRAMES, 940
Handwheel, 931
Programming, 936
Reference point approach, 950
Startup, 947
Indexing axis
Parameter setting, 934
Indexing axis in position, 1072
Indexing positions
Number, 934
Indexing positions table, 934
Infeed, 799
Initial learning, 418
Input override for geometry axis (1, 2, 3), 1028
Input values, 603
Measurement types, 604
Setpoints, 606
Interface, 279, 598
Interface signals
Activate handwheel (1 to 3), 1039
Active machine function for geometry axis (1, 2,
3), 1034
Active machine function INC1, ..., continuous, 1046
Continuous machine function, 1042
Contour handwheel active (1 to 3), 1032
DRF selected, 1032
Handwheel active (1 to 3), 1044
Handwheel active (1 to 3) for geometry axis, 1033
Handwheel override active, 1032, 1044
JOG - Approaching fixed point 0/1/2, 1043
JOG - Approaching fixed point active, 1047
1116
JOG - Approaching fixed point reached, 1047
Machine function INC1, INC10, INC100, INC1000,
INC10000, INCvar, 1042
Plus and minus travel command, 1046
Plus and minus travel command (for orientation
axis), 1035
Plus and minus travel commands (for geometry
axis), 1034
Plus and minus traverse keys, 1041
Plus and minus traversing request, 1045
Plus and minus traversing request (for geometry
axis), 1033
Plus and minus traversing request (for orientation
axis), 1035
Rapid traverse override, 1040
Traversing-key lock, 1040
Interpolation, 96
Linear, 760
non-linear, 761
with G0, 760
Interpolation cycle, 98
Interpolation functions, 794
Interpolator
Path, 760
Shaft, 760
Interpolatory compensation
Linear interpolation, 352
Methods, 349
Interrupt parts program, 497, 521
IPOBRKA, 781, 783
IPOENDA, 780
IS Feedrate stop/Spindle stop (DB31, ... DBX4.3), 876
J
JOG, 323, 537, 930
Approaching a fixed point, 325
JOG mode, 276
Jogging operation, 930
L
Language command
SPN, 728, 730
SPP, 727, 729
Language commands, 716
Large backlash compensation, 348
Large batch production, 94
Leadscrew error compensation, 353
Learning ON / OFF, 416
Learning the neural network, 414
Function Manual, 01/2008, 6FC5397-1BP10-3BA0
Extended Functions