Master RIDE User Manual page 18

INSTRUCTIONS OF ASSEMBLY
Part One
Please put the wheel in the fork, then assemble the washer and nut to fix them.
For front wheel, the same way as showed on the picture.
Important: Check the tightening of the nut ( with the help of wrench )
Part Two
Place the bracket in the column steering, using the wrench to tighten the
long screw.
Important: Tighten the stem well and ensure that the bracket is in the
correct center.
Part Three
Please use the wrench to fix the four screws and nuts, place the handlebar
by tightening the nuts in cross.
Attention: Please check the spigot and counter-nut are correctly tight.
all injuries.
 Maintain inflation of the tyres to no more than the maximum inflation marked on the side of the tyre.
 If any component is damaged or not functioning properly, it should be replaced before the product is used.

Avoid sharp bumps, drainages, grates and sudden surface changes.
Part Four
After finished the assemblage, you must adjust the back brake and
inflatable tyre with a suitable pressure.
IMPORTANT: PLEASE READ THIS MANUAL THOROUGHLY BEFORE
ASSEMBLING, RIDING OR PERFORMING MAINTENANCE ON THIS
SCOOTER.
WARNING:

Maximum Child's weight: 80 KGS

For ages of 6 and Up

Check and tighten bolts and screws before every ride.

Make sure all components are functioning properly before
every ride.

Rider should wear proper protection while using this product.
Please wear a helmet, knee and elbow pads, and shoes. This
will greatly reduce the chance of injury, but cannot protect form
18
EN