Check The Indicators And Settings; The Status Led; The Transmitter Channel Button - Bose Homewide Wireless Audio Link Link AL8 Owner's Manual

English Dansk
To control volume when a non-Bose product is the sound source:
• There is no need for an expansion room remote control.
• Use the remote that came with the tuner/receiver in the room where it is connected to the
transmitter.
• Use the volume control on the system, radio, or powered speakers connected to the
receiver in the other room.
To control non-Bose or older Bose
• Use a Bose
LIFESTYLE
• Use the product remote or console control for local volume adjustments.

Check the indicators and settings

Before you use the audio link, you may want to check some of the indicators and settings
that make your expansion products work together smoothly.

The Status LED

On the connection panel of both the transmitter and the receiver, the Status LED indicates
how the two units are communicating, as shown in the table below.
Status LED
On the
transmitter
On the
receiver
On the receiver, a blinking or solid orange light indicates a communications problem. Reposi-
tioning the transmitter, receiver, or both, may resolve the problem and cause both LEDs to
change to solid green. For further information, refer to "Troubleshooting" on page 11.

The transmitter Channel button

You can use the Channel button to narrow the selection of frequencies the transmitter uses.
The transmitter is factory-set to avoid WiFi Channel 11. This helps prevent performance
problems, such as slow or intermittent data transmissions, on a wireless network. If you have
a wireless network set up on another channel, you can set up your transmitter to avoid that
channel, or you can move the WiFi network to Channel 11.
Deutsch Español
® link remote control or the PERSONAL
® system in the main room.
Blinking green
Searching for
receiver
Searching for
transmitter
Français Italiano
® products in the expansion room:
® music center II to select audio from the
Solid green Blinking orange
Receiver Not
located applicable
Solid signal Weak signal
received received
Nederlands Svenska
S
ETUP
Solid orange
Powered on,
no communication
Weak or no signal
received