Instructions For Non-Bose Or Older Bose Products - Bose Homewide Wireless Audio Link Link AL8 Owner's Manual

Svenska Nederlands
S
ETUP
Instructions for non-Bose or older Bose
The Bose
not Bose link-compatible.
You can use non-Bose products in the following ways:
• A tuner/receiver as a sound source connected to the transmitter or in an expansion room
connected to the receiver
• Powered speakers connected to the receiver
You can use older Bose products as follows:
• Powered speakers, a radio, or system with its own volume and on/off controls and line-
level female RCA input jacks connected to the receiver
Any of the above products require the use of an RCA to DIN adapter cable for connecting to
the transmitter, the receiver, or both. An adapter kit, which contains two of these cables, is
available from Bose.
Note: To order the adapter kit, contact Bose and request Part Number 285320-207. For Bose
contact information, refer to the address sheet included in the carton.
To use an adapter cable:
The RCA connectors are color-coded, red for right and white for left.
1. Insert the adapter cable DIN connector into the Bose
2. Insert the adapter cable RCA connectors into the Audio Out jack on the connection panel
Figure 7
Source Product
Audio Output
Connections using
the adapter cable
L
R
3. Complete the connections using the power pack:
–
–
Note: For information on the meaning of the different Status LED lights, refer to "Check the
indicators and settings" on page 9.
In the room where your AR1 receiver is connected using the adapter cable, be sure to set
your Bose link remote or PERSONAL
Italiano Français
®
link AL8 Homewide Wireless Audio Link also works with some products that are
or receiver (OUTPUT) jack, as appropriate.
of the audio source or the Audio In jack on the expansion room product. Match left to left
and right to right.
Transmitter
Adapter cable
Insert the small plug on the power pack cable into the AC Power jack on the transmitter
or receiver.
Insert the small connector end of the power cord into the jack on the power pack. Plug
the other end of the cord into an AC (mains) wall outlet. The Status LED lights to verify
this power connection.
Español Deutsch
products
®
® link jack on the transmitter (INPUT)
Expansion Room Product
Audio Input
L
R
®
Bose link
INPUT
® music center II for use in Room "O."
Dansk English
Receiver
Bose
OUTPUT
Adapter cable
®
link