Manual Structure - Omron Sysmac NA Series User Manual

Manual Structure

Page Structure and Markings
The following page structure is used in this manual.
Level 2 heading
Level 3 heading
A step in a procedure
Indicates a procedure.
Special information
Icons indicate precautions,
additional information, or
reference information.
Manual name
Note This illustration is provided only as a sample. It may not literally appear in this manual.
NA-series Programmable Terminal Soft-NA User's Manual (V126)
3-3 Installing NA-series PTs
3-3-1 Installation in a Control Panel
Installation in a Control Panel
The NA-series PT is installed by embedding it in a control panel. Panel Mounting Brackets and a Phillips screwdriver are
required to mount the NA-series PT. The required number of Panel Mounting Brackets are included with the NA-series PT.
Panel Mounting Bracket Phillips screwdriver
Use the following installation procedure.
1
Open a hole in which to embed the NA-series PT with the following dimensions and insert the
NA-series PT from the front side of the panel.
Vertical
Horizontal
Recommended panel thickness: 1.6 to 6.0 mm
Model Dimensions
NA5-15W +1/-0 +1/-0
392 × 268
NA5-12W +1/-0 +1/-0
310 × 221
NA5-9W
+1/-0 +1/-0
261 × 166
NA5-7W
+ 0.5/-0
197 × 141
Additional Information
You can use an NS-USBEXT-1M USB Relay Cable to extend the USB slave connector on the
back panel of the NA-series PT to the front surface of a control panel. If you use the USB Relay
Cable, open a hole with the following dimensions and install the Cable.
2
Attach the panel mounting brackets from the back of the panel as shown in the following figure.
The number of mounting brackets depends on the size of the NA-series PT, as shown in the following
table. Refer to Bracket Mounting Locations for Different NA-series PT Sizes on page 3-8, below.
Model Number of Panel Mounting Brackets
NA5-15W 8 locations
NA5-12W 6 locations
NA5-9W 4 locations
NA5-7W 4 locations
Catch the brackets in the mounting holes in the NA-series PT, pull forward lightly, and then use
a Phillips screwdriver to tighten the screws and secure the NA-series PT to the panel, which will
be held between the mounting brackets and the NA-series PT.
NA Series Programmable Terminal Hardware User's Manual (V117)
3 Installation and Wiring
mm (horizontal × vertical)
mm (horizontal × vertical)
mm (horizontal × vertical)
+0.5/-0
mm (horizontal × vertical)
3 - 5
Manual Structure
Level 1 heading
Level 2 heading
Level 3 heading
Give the current
headings.
Page tab
3
Gives the number
of the main section
3