3.
Adjust the volume level of the input channels to
which your instruments or microphones are
connected by moving the corresponding faders.
On the n12 if you set the Meter section's [INPUT
METER] switch to POST, you will be able to use the
input meter of each channel to check the post-fader
signal level. If the C-R SOURCE SELECT [ST] switch
in the Control Room section is turned on, you can
monitor the STEREO bus signal in the Control Room.
If necessary, re-adjust the monitoring level by
rotating the [CONTROL ROOM LEVEL] control or the
[C-R PHONES] control.
POST
INPUT CHANNEL
INPUT
METER
INPUT A
INPUT B
PRE
CHANNEL
FADER
INPUT
METER
POST
PAN
A Hands-On Guide to the n8/n12
Owner's Manual
27