Master Control Section - Yamaha DIGITAL MIXING STUDIO N12 Owner's Manual

Front and Rear Panels

Master Control section

1
2
3
4
5
6
7
1 Reverb section
This section enables you to set the type, output level,
and other settings for the internal digital reverb.
REVERB [TYPE] switch
This switch determines the type of internal digital reverb.
Each press of the switch cycles through different
effect types in this order: HALL → ROOM → PLATE.
HALL Simulates reverberation in a concert hall.
ROOM Simulates reverberation in a room.
PLATE Simulates reverberation of a plate echo.
[REVERB TIME] control
This control adjusts the reverb time (duration of
reverberation) of the internal digital reverb. Rotating
the knob counter-clockwise will shorten the duration,
16
Owner's Manual
and rotating it clockwise will extend the duration.
REVERB [LEVEL] control
This control adjusts the output level of the internal
digital reverb. The "▼" position corresponds to the
nominal level (0 dB).
[TO AUX]/[TO REC]/[TO ST] switches
These switches route the output signal from the internal
digital reverb to the AUX, REC, or STEREO buses. Turn
the desired switch on (
internal digital reverb to the desired buses.
2 2TR TO ST section
This section enables you to adjust the level of and
route the signal input from the 2TR IN jacks (page 20).
[LEVEL] control
Adjusts the level of the signal input from the 2TR IN jacks.
The "▼" position corresponds to the nominal level (0 dB).
[ON] switch
This switch determines whether the 2TR IN signal will be
sent to the STEREO buses. When the switch is turned on
( ), the 2TR IN signal is sent to the stereo buses.
3 DAW TO ST section
This section enables you to adjust the level of and
route the stereo signal transmitted from the DAW
(DAW IN 1/2).
[LEVEL] control
This control adjusts the level of the stereo DAW
signal to the STEREO buses. The knob set to the "▼"
position corresponds to the nominal level (0 dB).
[ON] switch
This switch determines whether the stereo output signal
from the DAW will be routed to the STEREO buses.
When the switch is turned on (
from the DAW will be sent to the mixer's STEREO buses.
If you turn on the C-R SOURCE SELECT
Only
NOTE
[5.1] switch, the DAW TO ST [ON] switch will be
disabled.
4 STEREO [BAL] control
This control adjusts the left and right volume balance
of the stereo channels (STEREO L/R).
5 [PFL] (Pre-Fader Listen) switch
If you want to monitor pre-fader input channel
signals when you are using the Solo function, turn
this switch on ( ).
While this switch is turned on, if you also
Only
NOTE
turn the [SOLO] switch on, the monitor signal
volume may become very loud. In this case, use the
[SOLO LEVEL] control (page 17) to adjust the
monitoring volume level. The monitoring volume
level of the n8 is always attenuated by 12 dB.
6 STEREO [ON] switch
This switch turns on and off the signal output from
the ST OUT jacks. When the switch is on (
signal is output from the ST OUT jacks.
7 STEREO fader
This fader adjusts the level of the signal output from
the ST OUT jacks. The "0" position corresponds to
the nominal output level (0 dB).
) to route the output from the
), the stereo output
), the