How To Use The Built-In Timer - Yamaha EMX-120CD Owner's Manual

HOW TO USE THE BUILT-IN TIMER

CD CHANGER RECEIVER EMX–120CD
PROGRAM
STANDBY/ON
ECHO MUSIC ECHO
KARAOKE MEMORY
PHONES
DISPLAY MEMORY
TIME ADJ
2
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE
DISC SKIP
CD TUNER
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
SLEEP
A/B/C/D/E PRESET/TUNING/BAND
DISC
OPEN/CLOSE CHANGE
1 2 3
DISC DISC DISC
INPUT SELECTOR VOLUME
CD TUNER
VCR•LD/TV•CD•TAPE/MD•TUNER
MIC TONE MIC MIC MIXING
AUTO/MAN'L REPEAT TIME INPUT TRIM
TIMER HOUR MIN
NORMAL SOFT MIN
2- 2-
CD TUNER
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
REPEAT RANDOM OPEN/CLOSE
STOP PLAY/PAUSE
2-
INPUT
FLAT
KARAOKE MUSIC PROGRAM
STANDBY/ON
DISPLAY
2
VOLUME
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns into the standby mode automatically.
1
Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For CD player:
Load a disc on the disc table. If more than one disc are
loaded on the disc table, select the disc by using the
DISC selector buttons or the DISC SKIP button.
MAX
2
Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
Note
The display mode will be changed to the next mode
after about 8 seconds elapse in turn automatically. If the
mode is changed before the setting is completed, call the
mode again by pressing the DISPLAY button once or
more.
Setting procedure:
Current time
Check to be sure that the current time is correct, and
press the TIMER button so that "TIMER" lights up on
the display.
Source selecting mode
Select the source (TUNER or CD) to be played with
the INPUT SELECTOR buttons.
* If "TUNER" is selected, soon it is changed to the
frequency display mode. In this mode, you can
select the station to listen to by the timer play by
using the PRESET/TUNING/BAND selector button,
A/B/C/D/E button and
E-40
Current time (TIMER on/off mode)
Source selecting mode (TUNER, CD)
ON TIME/Time setting mode
OFF TIME/Time setting mode
Normal display mode
/ buttons.