How To Use The Built-In Timer - Yamaha EM-203VCD Owner's Manual

HOW TO USE THE BUILT-IN TIMER

VIDEO CD CHANGER RECEIVER
VIDEO CD
Version 2.0 / Playback Control
PROGRAM
STANDBY/ON
ECHO MUSIC ECHO
KARAOKE
MEMORY
PHONES
DISPLAY MEMORY
TIME ADJ
2
VCD/CD
1
1
6
6
A
TIME PROG
MODE
DISC SKIP PREV
VCD/CD TUNER
2-
CENTER/REAR
TEST
/DELAY
ECHO/KEY
LEVEL
SLEEP
A/B/C/D/E
DISC
OPEN/CLOSE CHANGE
1 2 3
DISC DISC DISC
INPUT SELECTOR VOLUME
VCD/CD TUNER
VCR•LD/TV•VCD/CD•TAPE/MD•TUNER
MIC TONE MIC
AUTO/MAN'L REPEAT TIME INPUT TRIM
TIMER HOUR MIN
NORMAL SOFT
2-
2-
TUNER
2 3 4 5
2 3 4 5
7 8 PRESET
7 8 9 0
B C D E
+
I0
INDEX RANDOM OPEN/CLOSE
NEXT RETURN SELECT
STOP PLAY/PAUSE
INPUT
MUSIC TIME INDEX
PROGRAM INTRO DIGEST
STANDBY/ON
KARAOKE
VOLUME
Timer play
By using the built-in timer, you can set the time when the unit
turns on and a source begins playing automatically, and the
time when the unit turns into the standby mode automatically.
1
Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For Video CD player:
PRESET/TUNING/BAND
Load a disc on the disc table. If more than one disc are
loaded on the disc table, select the disc by using the
DISC selector buttons or the DISC SKIP button.
MIC MIXING
2
Press the DISPLAY button.
MIN MAX
Whenever the DISPLAY button is pressed, the display
mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
Note
The display mode will be changed to the next mode
after about 8 seconds elapse in turn automatically. If the
mode is changed before the setting is completed, call the
mode again by pressing the DISPLAY button once or
more.
Setting procedure:
Current time
Check to be sure that the current time is correct, and
press the TIMER button so that "TIMER" lights up on
the display.
Source selecting mode
Select the source (TUNER or VCD/CD) to be played
with the INPUT SELECTOR buttons.
* If "TUNER" is selected, soon it is changed to the
E-44
Current time (TIMER on/off mode)
Source selecting mode (TUNER, VCD/CD)
ON TIME/Time setting mode
OFF TIME/Time setting mode
Normal display mode
frequency display mode. In this mode, you can
select the station to listen to by the timer play by
using the PRESET/TUNING/BAND selector button,
A/B/C/D/E button and / buttons.