Basic Operation - Yamaha 480 Owner's Manual

This manual describes how to operate this unit by using the remote control transmitter.
To operate this unit on the front panel, use the corresponding buttons on the front panel.
1
1
2
OPEN/CLOSE
Display information at disc play
3 4 5 6 7 8 9 10 11 12
Shows the track number selected or being played.
Shows the time displays. (Refer to "Selecting time
displays" on page 10.)
CDX-580 and CDX-480 only
Shows the level of signals output into an amplifier or the
headphone level adjusted by using the OUTPUT LEVEL
buttons.
Displays the numbers that correspond to the numbers of
tracks (as high as number 20) on the disc. After each
track is played, its corresponding number disappears so
the number of remaining tracks (and their numbers) can
be seen at a glance.
To turn off the power
Press the POWER button again.
8

BASIC OPERATION

POWER
AUTO
DISPLAY OFF
POWER
Label side
upward
Disc tray
SINGLE
2, 3 OPEN/CLOSE
DIMMER
PROG TAPE CLEAR
SPACE S/F
REPEAT
1 2 3
4 5 6
7 8 9
SKIP PAUSE
SEARCH INDEX
–
OUTPUT LEVEL
SYNCHRO
3
Close the disc tray.
4
Play will begin from the first track of the disc.
Notes
•
After closing the disc tray by pressing the OPEN/CLOSE
button, the display shows the total number of tracks and the
total recorded time of the disc for a few seconds.
TOTAL
1 2 3 4 5 6 7 8 9 10 11 12
•
Additionally, you can close the disc tray by pressing the
PLAY (PLAY/PAUSE) button, a numeric button or the
RANDOM button, or by pressing the front edge of the disc
tray gently. If the tray is closed in these ways, play will begin
automatically, however, the display will not show the total
number of tracks and the total recorded time of the disc.
TIME
PEAK
RANDOM
+
10
0
PLAY 4
STOP
+
OPEN/CLOSE
PLAY