Changing Brightness Of The Display - Yamaha 480 Owner's Manual

Changing brightness of the display

CDX-880, CDX-580
You can change the brightness of the display (or turn off the illumination) by pressing the DIMMER button.
During play
Normal illumination
Dim
"OFF"
* While the display illumination is off,
the AUTO DISPLAY OFF indicator
on the front panel is illuminated.
CDX-480
If desired, you can change brightness of the display
in three degrees by pressing the DIMMER button.
When you listen with headphones
Connect the headphones to the PHONES jack and adjust the
volume by using the OUTPUT LEVEL buttons. At that time,
note that this adjustment will also vary the signal level output to
the amplifier.
CDX-880 only
* If the FIXED (LINE OUT) terminals on the rear of this unit
are connected to the amplifier etc., the use of the OUTPUT
LEVEL buttons does not vary the signal level output to the
amplifier.
Open/close the control door
When it is not necessary to operate controls inside the control
door, close the door.
To close the door
DIMMER
AUTO
DISPLAY OFF
CDX-880 only
During stopped or paused
Normal illumination
Dim
Dim
(The AUTO DISPLAY OFF indicator lights up.
In this state, if a disc is played, the display
illumination will be turned off.)
Normal illumination
DIMMER
Slightly dim
PHONES
To open the door
Dim
+
–
OUTPUT LEVEL
11