Invacare Carroll CS Series User Manual page 27

1153410-Q
Fig. 4-1
1. Release/cut the straps A that secure the packaged bed
B to the shipping pallet C.
2. Remove the straps from the assembly.
The bed is packaged so that the wheels (not
shown) of the bed are always located on the
same side as the latch mechanisms D.
Lowering the bed toward the side where the
latch mechanisms were located will ensure that
the wheels will be facing the ground when the
bed is unpackaged.
The use of two people is preferred when
lowering the bed to the floor.
3. Grab cross bar here E and slowly lower the bed toward
the floor on the side where the straps were released/cut
and removed.
4. Remove the corrugated wrap F.
WARNING!
Risk of Injury or Damage
Bed damage or personal injury may occur if
bed is dropped. To avoid:
– Slowly lower the bed to the floor.
– Use additional people if necessary.
Set-up
27