Switch On The Machine - Xerox WorkCentre 4260C Quick Use Manual

Switch On the Machine

Once the machine has been assembled it must be configured. This is done using the
Product Enablement Key when the machine is switched on for the first time.
The Product Enablement Key is
delivered in a plastic tube inside the
box with the machine. The procedure
to configure the machine is as
follows:
1
Locate the tube containing the
Product Enablement Key. Remove
the plastic card and carefully press
out the key.
2
Connect the Power cord to the machine and a suitable power supply outlet.
3
Switch on the machine.
4
Install the Product Enablement Key into the Card Reader Slot at the back of the
machine.
Card Reader slot
5
The Language Default screen will be displayed. Select your chosen language and
then select Save.
6
The Installation Wizard screen will be displayed. Select Next.
7
The Product Enablement Settings screen will be displayed. Follow the instructions on
the screen.
NOTE:
When the Green LED light stops blinking and remains on continuously (about
10 seconds), the configuration is successful.
8
Remove the Product Enablement Key and select Next on the display.
quick use guide
Green LED
Product Enablement Key
5