Using Manual Bypass Feed - Xerox Wide Format 721P Operator's Manual

MEDIA

Using Manual Bypass Feed

24
When the desired media is not loaded in the printer, you can
bypass the media drawers and manually load cut sheet media into
the printer.
To manually feed cut sheets into the printer:
1. Select the appropriate cut sheet for the print job.
NOTE:
The printer will accept any media type, regardless of the media
type specified. Ensure that the media type is correct or the toner
image may rub off of the print as the printer uses media type to
determine fusing temperature.
2. Adjust the media guides to the correct size.
Paper Guide
3. Feed the cut sheet media squarely into the printer, curl side
down and between the guides. For media 24" or wider, the
printer will pre-feed the sheet into the feeder. For media
smaller than 24", the printer will feed the media when the print
job starts.
841mm or wider (greater than 24"): 1 sheet only
279mm (11") to 609mm (24") width: up to 50 sheets (457mm -
18 inch length maximum) fed long edge
NOTE: Install the wire form holder tray for paper larger than
18" (447mm).
4. From the client workstation or the scanner, specify Manual
Feed as the media source.
5. Submit the print job or scan the document.
XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL