Table 8 Electrical Specifications - Bard 11EER WA Series Installation Instructions Manual

Rated Volts &
MODEL
Phase
W12AB-A0Z
A03 230/208-1
A05
W12AB-K00
115-1
K02
W12AB-D0Z
240/220-1
D03
 Maximum size of the time delay fuse or circuit breaker for protection of field wiring conductors.
 Based on 75°C copper wire. All wiring must conform to the National Electrical Code and all local codes.
 These "Minimum Circuit Ampacity" values are to be used for sizing the field power conductors. Refer to the National Electrical code
(latest version), Article 310 for power conductor sizing.
CAUTION: When more than one field power circuit is run through one conduit, the conductors must be derated. Pay special
attention to Note 8 of Table 310 regarding Ampacity Adjustment Factors when more than three current carrying
conductors are in a raceway.
IMPORTANT: While this electrical data is presented as a guide, it is important to electrically connect properly sized fuses and
conductor wires in accordance with the National Electrical Code and all local codes.
TABLE 8
Electrical Specifications
No. Field Power

Circuits
Minimum Circuit
Ampacity
1 9
1 20
1 28
1 17
1 28
1 9
1 20
Single Circuit
 
Maximum External Field Power
Fuse or Ckt. Brkr. Wire Size
15 14
20 12
30 10
30 10
30 10
15 14
20 12

Ground Wire
14
12
10
10
10
14
12
Manual 2100-715B
Page 23 of 25