Storage Procedure - Suzuki V-Strom DL650 2017 Manual

STORAGE PROCEDURE

AND MOTORCYCLE
CLEANING
STORAGE PROCEDURE
If the motorcycle is to be left
unused for an extended period of
time, it needs special servicing
requiring appropriate materials,
equipment and skill. For this rea-
son, Suzuki recommends that you
trust this maintenance work to
your Suzuki dealer. If you wish to
service the machine for storage
yourself, follow the general guide-
lines below:
MOTORCYCLE
Clean the entire
Place the motorcycle on the cen-
ter stand on a firm, flat surface
where it will not fall over. Turn the
handlebars all the way to the left
and lock the steering, and remove
the ignition key.
FUEL
1. Fill the fuel tank to the top with
fuel mixed with the amount of
gasoline stabilizer
mended by the stabilizer man-
ufacturer.
2. Run the engine for a few min-
utes until the stabilized gaso-
line fills the fuel injection
system.
ENGINE
1. Pour one tablespoon of motor
2. Drain the engine oil thoroughly
3. Cover the air cleaner intake
BATTERY
1. Remove the battery from the
2. Clean the outside of the bat-
motorcycle.
3. Store the battery in a room
TIRES
Inflate the tires to the normal
pressure.
EXTERNAL
•
recom-
•
•
PROCEDURE DURING
STORAGE
Once a month, recharge the bat-
tery with a specified charging rate
(Ampere). Standard charging rate
is 1.2A × 5 to 10 hours.
9-2
oil into each spark plug hole.
Reinstall the spark plugs and
crank the engine a few times.
and refill the crankcase with
fresh engine oil all the way up
to the filler hole.
and the muffler outlet with oily
rags to prevent humidity from
entering.
motorcycle by referring to the
BATTERY section.
tery with a mild soap and
remove any corrosion from the
terminals and wiring harness.
above freezing.
Spray all vinyl and rubber
parts with rubber protectant.
Spray the unpainted surfaces
with rust preventative.
Coat the painted surfaces with
car wax.