Table of Contents
Advertisement
Re-load the Correction Constants
1.
Insert the "EEPROM Backup Disk" (created earlier) into the disk drive.
2.
Press (-1 ' Sl$&?T?%SK' ~ ;TNT%KEDISF. Use the front panel knob to highlight the
file "N12345" where N12345 represents the file name of the EEPROM data for the analyzer.
3.
Press Rl?I'URN RECALL ' STiTK to down load the correction constants data into the
instrument EEPROMs.
Press IPreset) to load the EEPROM Constants. Verify that good data was transferred to
4.
EEPROM by performing a simple measurement.
Re-load the Instrument States
If you want to re-load the analyzer' s instrument states from your backup disk (created earlier),
refer to "Printing, Plotting, and Saving Measurement Results," located in the User' s Guide. This
procedure may be very time consuming, depending on the number of instrument states that
you choose to re-load. Each instrument state file will have to be renamed.
Configure the Analyzer to Produce a Time Stamp
You
can set a clock, and then activate it, if you want the time and date to appear on your
hardcopies.
SET YEAR and enter the current year (four digits), followed by Ixl).
SET MONTH and enter the current month of the year, followed (xl.
SET DAY and enter the current day of the month, followed by Ixl).
SET HOUR
Press
SET MINUTES
14
and enter the current hour of the day (O-23), followed by a.
and enter the next immediate minute, followed by 1x11.
Installation Note 09720-90372
Advertisement
Table of Contents
