Wolfcraft 6156 Owner's Manual page 17

Attach Short Legs
(Model 6156 Only)
AJ, zinc (16)
AP, black (24)
AN, black (8)
AQ, black (8)
1. Mount four legs (E-1 and E-2) to table
using four pan head screws (AJ) and
four toothed washers (AP) per leg.
Use a #3 Phillips screwdriver to keep
from stripping the screw heads.
NOTE: Leg (E-2) is mounted on the
front left position of the table top with the
safety sticker toward the front of the
table. See Figure 10.
AP AQ
E-1
AJ
AP
AN
E-1
B-2
E-1
E-2
B-1
Figure 10
17
2. Use 2 pan head screws (AN), 2
toothed washers (AP), and 2 hex nuts
(AQ) to attach a support (C or D) to
each leg (E).
Alignment of Tabletop and
Extensions
Turn tabletop/extension assembly over
and check alignment of extensions and
tabletop by sliding miter guide assembly
through slot. Loosen screws and adjust
alignment of tabletop and extensions if
necessary. Retighten screws.
NOTE: Extension (B-2) to be mounted
on the right side of the table top. See
Figure 11.
SAFETY
STICKER
B-1
SAFETY
STICKER
B-2
O N
PU LL
O FF
PU SH
RE SE T
T S
T LE
O U
Figure 11