Advertisement
Quick Links
Hydraulic Tank Kit
Greensmaster
Model No. 136-8550
This product contains a chemical or chemicals known to the State of California
Note:
Refer to
Figure 1
equipped).
1. Carbon canister
2. Capscrew
3. Neoprene washer
4. Flat washer
5. Spacer
6. Capscrew
7. Lock washer
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3120 or 3150 2-Wheel Drive Traction Unit
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
during the removal and installation of the hydraulic tank and leak detector tank (if
8. 90° barb hydraulic fitting
9. O-ring
10. Hydraulic hose (pump inlet) 17. Straight hydraulic fitting
11. Strainer
12. Flange bushing
13. Flat washer
14. Capscrew
Register at www.Toro.com.
WARNING
CALIFORNIA
Figure 1
15. Barbed hydraulic fitting
16. Hydraulic hose
18. Oil-level sensor
19. Hydraulic tank
20. Hose clamp
21. Overflow hose
Form No. 3417-561 Rev A
Installation Instructions
22. Leak-detector-solenoid coil
23. Tee fitting
24. Hex-head plug
25. Leak detector tank
Original Instructions (EN)
All Rights Reserved *3417-561* A
Printed in the USA
g229181
Advertisement
Related Manuals for Toro 136-8550
Summary of Contents for Toro 136-8550
- Page 1 Form No. 3417-561 Rev A Hydraulic Tank Kit Greensmaster ® 3120 or 3150 2-Wheel Drive Traction Unit Model No. 136-8550 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installation Preparing the Machine g229099 Figure 2 No Parts Required 1. Pump-inlet hose 2. Hydraulic pump Procedure Clamp the pump-inlet hose (Figure 2) to control the hydraulic-fluid drainage. WARNING Remove the hose from the pump and release Hydraulic fluid escaping under pressure can the clamp to drain the hydraulic fluid from the penetrate skin and cause injury.
- Page 3 Remove the capscrews and lock washers from the solenoid-valve assembly. Remove the leak-detector tank from the machine. Installing the Hydraulic Tank Parts needed for this procedure: Removing the Hydraulic Hydraulic tank Tank Breather Plug No Parts Required Procedure Procedure Lightly lubricate the O-rings of each fitting with Note: hydraulic fluid.
- Page 4 Apply anti-seize lubricant to the threads of the capscrews. Use the capscrews, flat washers, neoprene washers, and spacers to secure the leak-detector tank and carbon canister to the hydraulic tank. Torque the capscrews to 3.4 to 6.7 N∙m (30 to 60 in-lb). Important: Do not overtighten the g229104...