Table of Contents
Advertisement
7.5 Assembling the product
7.5.1
During assembly
First assemble all section/curve modules for a system on the appropriate base frame.
„
These assembled components will be referred to as system sections.
Assemble the system sections at the position of later use.
„
Use a precision level (min. sensitivity 0.02 mm/m) to make sure the base frame is
„
plumb, level and square.
Use these system sections to assemble the overall system.
„
Overall systems with a length ≥ 10 m
Begin assembly with a center system section with a section module .
„
These will be referred to as reference system sections.
n
5
Fig. 28:
Order of assembly for overall system with a length ≥ 10 m
Mount additional system sections with section/curve modules on the left and
„
right in a symmetrical manner.
Make sure all other mounted system sections are plumb, level and square with
„
the reference system section.
3
1
2
3 842 559 521/2018-07, MIT: ActiveMover, Bosch Rexroth AG
Assembly
51/172
4
n-1
557 186-28
Advertisement
Table of Contents
