Table of Contents
Advertisement
6.2 Storing the product
• Always set the product down on a flat surface.
• Protect the product from mechanical stress.
• Protect the product from environmental factors, such as dirt and moisture.
• Observe the ambient conditions, see "Technical data" on page 169.
7 Assembly
7.1 Unpacking
Lift the product out of the packaging.
„
Dispose of the packaging in accordance with the regulations in your country.
„
7.2 Installation requirements
During installation, be sure to maintain the ambient conditions specified in
„
"Technical data" (see page 169).
7.2.1
Installation position
„
Install the product so it is level, plumb, square and true. This ensures proper
functioning and prevents premature wear.
7.3 Required tools
7.3.1
Mechanical
• Precision level (min. sensitivity 0.02 mm/m)
• Precision straight edge
• Rubber mallet
• 1 set of wrenches
• 1 set of hex socket wrenches
• Precision straight edge
• 0.1, 0.2, 0.25, 0.5 mm shims
7.3.2
Electrical
• Various screwdrivers with insulated handles
• Wire cutters with insulated handles
• Wire stripper with insulated handles
• Multimeter
3 842 559 521/2018-07, MIT: ActiveMover, Bosch Rexroth AG
Assembly
49/172
Advertisement
Table of Contents
