Table of Contents
Advertisement
Section 3 ► Operation
3.3 navigating the Menus
On-Line Help >
Wolf Cinema Owner's Manual
most of the controls for the projector are
accessed from within the projector's menu
system. There are several groups of related
functions, with each group selectable from
the main menu as shown at right. Press
at any time to display this main menu.
menu
On the remote keypad, either enter the
number corresponding to the function menu
you wish to access, such as
Picture adjustments menu, or use the
keys on any keypad to highlight
the desired option, then press
corresponding function menu or pull-down
list of further options will then appear.
With a function menu displayed, navigate in a similar manner—enter a menu option number for
any numbered option, or use the keys to highlight the desired option, then press (enter). extra
long menus have a scroll bar on the right—use the arrow keys to access the remainder of the
menu. locked items or items that do not pertain to the current action or condition appear dimmed
and cannot be selected.
nOTes: 1) if there is no signal present, all source-dependent adjustments are disabled. 2) after
15 minutes of inactivity, the projector leaves the menu system and returns to the presentation. 3)
The Information menu is read-only.
When finished with a function menu, do one of the following:
• Press
to return to the previous screen
exit
• Press
to leave the menu system and return to the presentation
menu
if at any time you are uncertain what to do next, press
about the current menu or highlighted option. Press
text is included at the bottom of some menus.
Lamp
Lamp Hours
0
Lamp S/N
?
1.
Lamp Message
2.
Lamp Limit
1000
3.
Lamp Mode
Power
4.
Power
500
Intensity
5.
0
6.
Iris
3
7.
Lamp History
8.
Change Lamp
3-10
1. Geometry and Position
2. Picture Adjustments
3. Channel Setup
4. Display Setup
5. Lamp
6. Information
7. PIP
for the
2
8. Test Pattern
. The
Help
again to exit. in addition, a line of "hint"
Help
Help
Enable a notice upon power-up
indicating the lamp has logged a given
number of hours as specified by
the lamp limit (default is lamp specific).
to display summary information
Advertisement
Table of Contents
