Table of Contents
Advertisement
3.5 adjusting the Image
Before You Begin >
•
aUTO sOURCe:
if checked, (default), the projector can automatically locate this channel
when an incoming input signal matches. if not checked, the projector can locate the selected
channel only when it is directly selected via
signal will not result in a channel change.
•
lOCKeD:
if checked, all of the Picture adjustments for this channel are disabled. if
unchecked (default), all available Picture adjustments can be adjusted as desired. you
cannot use auto Setup with a locked channel.
•
PReVIOUs CHannel:
previous channel in the Channel Setup list.
•
neXT CHannel:
Select this option to see or change Channel Edit settings for the next
channel in the Channel Setup list.
The most commonly used options for image adjustments are accessed through two menus:
Geometry and Position (
appear in the main menu. From either of these two menus, you can change settings affecting the
image from the current channel by working with the appropriate slide bars, checkboxes and pull-
down lists.
will return to the previous menu (or to the presentation, if from the main menu)
exit
and accept any changes you may have entered. Settings are saved with the current channel.
From your presentation, you can access any of the individual options in these menus by pressing
followed by the appropriate two-digit number representing their location in the menu
menu
system. For example, press
Picture Adjustments menu.
note that for certain options, you may prefer to use a "direct key" from presentation level to go
directly to a particular option without traveling through the menu system (available for certain
display parameters only). For example, press
Press
to return to your presentation.
exit
nOTes: 1) To hide these "direct" slide bars, disable the "Display Slide bars" checkbox in the
Menu Preferences menu. 2) To hide the entire menu system from view, turn off the on-screen
display by pressing
OSD
Use Auto Setup
(
)
auto
For a good and efficient first step in perfecting the image, press
process in which the projector quickly optimizes critical display parameters such as size, position,
pixel tracking, etc., based on the type of incoming source data detected. an Auto Setup can save
considerable setup time, and you can still modify the adjustments as desired using menu options
described below.
3-19
Channel
Select this option to see or change Channel Edit settings for the
) and Picture Adjustments (
menu
1
to quickly access the "Gamma" option in the
menu
2
3
to access the "contrast" slide bar immediately.
Contrast
.
Section 3 ► Operation
on the keypad — and a change in input
), both of which
menu
2
. This initiates an automated
auto
Wolf Cinema Owner's Manual
Advertisement
Table of Contents
