Windsor Saber Glide 10052530 Operating Instructions Manual page 15

Windsor saber glide operating instructions

Table of Contents

5. SOLUTION CONTROL SWITCH

This switch controls the amount of solution flow to the scrub deck. There are 7 different flow settings. To

increase the solution flow, press the solution control switch (+). To decrease solution flow, press the top of

the switch (-). If the brush motors are turned off or the direction control pedal is in neutral, the flow is

automatically interrupted until the motors are turned on again, or the drive pedal is moved forward or reverse.

This feature prevents unintentional draining of the solution tank and allows the operator to adjust the solution

flow to the scrub deck without resetting each time the scrubbing operation is interrupted. If recycling option is

installed, this switch controls the amount of solution flow to the scrub deck by controlling the speed of the

pump.

NOTE: Press switch and hold momentarily each time to change solution flow.

INFORMATION DISPLAY

LESS SOLUTION

6. VACUUM/SQUEEGEE SWITCH

This switch independently controls the vacuum motor and squeegee position. To start the vacuum motor and

lower the squeegee to the floor, press the bottom of the switch. To raise the squeegee and turn off the

vacuum motor, press the top of the switch. The squeegee will raise after a 15 second delay, and the vacuum

motor will turn off 15 seconds later, in order to clear vacuum hose of recovered solution.

INFORMATION DISPLAY

Table of Contents

Saber glide sgj32 10052530 1000136404