Table of Contents
Advertisement
5. Hold the product with the left hand.
6. Put your right foot on the frame.
7. Pull the starter rope handle slowly until resistance
occurs.
8. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
9. Move the choke lever to the open choke position
until the choke lever stops.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Maintenance
Clean the external surface.
Make sure that the throttle control operates correctly.
Make sure that the stop switch operates correctly.
Do a check of the stop switch, refer to
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the air filter. Replace if it is necessary.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
Examine the air intake and make sure that it is not blocked.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages and cracks.
1144 - 002 -
10. Pull the starter rope handle repeatedly until the
11. If the engine does not start, do step 1 to step 10
12. Let the engine run for 2-3 minutes to become warm
To stop the product
1. Push the throttle lever to the stop position.
Maintenance
To stop the product on page 11 .
engine starts and continues to run.
again.
before operation.
CAUTION: Do not stop the product at full
speed.
Daily
X
X
X
X
X
X
X
X
X
Weekly
Monthly
X
X
11
Advertisement
Table of Contents
